A bit of background, its origins:

In 2004 an agreement was signed between the Spanish “Consejo Superior de Investigaciones Científicas” (CSIC) and the German “Max-Planck-Gesellschaft” (MPG) by which both organizations have 50 % ownership and management of the former German-Spanish Astronomical Center of Calar Alto, Economic Interest Grouping (CAHA, AIE) and, in particular, of its two telescopes of 2.2 m and 3.5 m aperture.

Within this agreement the CSIC and the MPG, through their respective institutes, “Instituto de Astrofísica de Andalucía” (IAA-CSIC, in Granada, Spain) and “Max-Planck-Institut für Astronomie” (MPIA, in Heidelberg, Germany), are committed to carry out a joint development program of new state-of-the-art post-focal instruments for CAHA.

The IAA and MPIA are research institutes in Astrophysics, Space Sciences, and technologies associated with the development of astronomical instrumentation both on the ground and in space.

One year later, in September 2005, the CAHA Instrumentation Committee issued its final recommendation regarding the first instrument to be developed under this agreement: the construction of an infrared camera for the 2.2 m telescope, in the spectral range of 0.9 µm to 2.5 µm with a pixel scale of 0.45 arcsec/px, to be attached to its Cassegrain focus. 45 arcsec/px, which would be coupled to its Cassegrain focus, in order to provide this telescope with a first-class instrument and decrease the time request pressure on the 3.5 m telescope.  To make a competitive instrument, the camera should have a large field, about 30 arcmin, using a mosaic of 4 infrared detectors of 2k×2k pixels.  The camera would be general purpose with its main scientific applications being wide-field imaging and sky survey.

This new instrument, on the one hand, would come to replace the MAGIC camera (Herbst, et al., 1993) built in 1993, of 256×256 pixels, for in the infrared range of 1 to 2.5 µm, which covered a field of view of 7×7 arcmin at the 2.2 m telescope, with a pixel scale of 1.62 arcmin/pix.  On the other hand, the new camera would have an internal cold pupil to be more sensitive and have better signal-to-noise ratio in the K-band than the Omega 2000 camera (Baumeister, et al., 2002) of the 3.5 m telescope.  In addition, the new camera would have four times the field of view of Omega 2000, with the same pixel scale.

The feasibility study was carried out between October 2005 and April 2006.

In July 2006, the CAHA Scientific Advisory Committee, selected PANIC from the three potential solutions investigated for this first instrument.

 

Instrument description:

PANIC (PANIC Panoramic Near-Infrared Camera) is the wide-field infrared camera for the 2.2 m and 3.5 m aperture telescopes of the Astronomical Observatory of Calar Alto (Almería, Spain).  This project has been developed in collaboration between the IAA-CSIC, MPIA and CAHA.

The instrument is optimized for the 2.2 m telescope, but can also be used at the 3.5m telescope with very good performance too.  Originally, and with the former detector (a mosaic of four infrared detectors of 2x2 HAWAII2-RG and 18 micron pitch), the camera had a field of view of 31.65 x 31.65 arcmin (0.446 arcsec/px) at the 2.2 m telescope, and of 15.6 x 15.6 arcmin (0.224 arcsec/px) at the 3.5 m telescope.  With the new detector upgrade (a monolithic HAWAII-4RG, consisting of 4096x4096 pixel matrix with 15 micron pixel pitch), the new field of view at the 2.2 m is 26.3 x 26.3 arcmin and 0.37 arcsec/px pixel scale.

Former Field of view of 30x30 arcmin

panic fullmoon panic first moon

 

Live image of the full moon on November 6, 2014, corresponding to the first light of PANIC.

The cryogenic optics has three flat fold mirrors with diameters up to 270 mm and eight lenses with diameters between 115 mm and 250 mm. A compact filter unit can carry up to 15 filters distributed over four filter wheels. The wheels have cryogenic stepper motors.

The instrument has a diameter of 1.1 m and it is about 1 m long. Since the there is a weight limit of only 400 kg at the 2.2 m telescope, a lightweight cryostat design is necessary. The aluminium vacuum vessel and radiation shield have wall thicknesses of only 6 mm and 3 mm respectively. Cooling is done by liquid nitrogen.

The instrument development encompasses the following work packages:

  • Optics
  • Cryostat and Mechanisms
  • Electronics
  • Detectors and Read Out electronics and
  • Software:
    • the Instrument control Software (GEneral InfraRed instrument Software, GEIRS and the Observation Tool, OT) and
    • the Data Reduction Software (the Quicklook and the science Pipeline, PAPI).

 diseño optico

Overview of the final optical design of PANIC.
 

A bit of history, its main milestones:

  • Feasibility study (October, 2005 – April, 2006).
  • Kick-off meeting (October, 2006).
  • Preliminary design review (November, 2007).
  • Successful Optics Final design review (September, 2008).
  • Mosaic of 2x2 HAWAII2-RG arrival to MPIA (March, 2009).
  • Optics procurement (May, 2009 – December, 2011).
  • Cryostat order (May, 2009).
  • Complete instrument Final design review (December, 2009).
  • Alignment, Integration and Verification phase: optics, mechanics, electronics and software at laboratory (May, 2010 – August, 2014).
  • First software integration tests (December, 2011).
  • Installation and commissioning at the 2.2 m and at the 3.5 m telescopes (October, 2014 – March, 2015).
  • PANIC first light at the 2.2 m telescope (November, 2014).
  • A new narrow band filter, Br-gamma, installed (January, 2016).
  • The CAHA director and PANIC's principal investigators signed an agreement on the provisional acceptance of the PANIC instrument (November, 2017).
  • New detector, monolithic HAWAII-4RG, order (September, 2018).
  • New detector arrival to MPIA (October, 2019).
  • New detector implementation phase at MPIA: mechanics, readout electronics and the control and data acquisition software, and tests (August, 2018 – October, 2022).
  • Installation and new first light at the 2.2 m telescope (December, 2022).
  • Commissioning at the 2.2 m telescope, several runs (December, 2022 – April, 2024).
  • PANIC 4K “tiger” team assembled and Development plan for operations at CAHA stablished (September, 2024).
  • Improvement of the detector data: Reset frame drift and non-linearity correction model (September, 2024 – April, 2025).
  • Hand over to CAHA (April, 2025).
  • CAHA offers PANIC in shared risk mode for 2025B.
panic telescope panic telescope.2jpg

 

PANIC installed at the 2.2 m telescope (left) and at the 3.5 m telescope (right), during its commissioning in 2014-2015.

PANIC 4K team:

 panic team4k

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PANIC 4K team, in alphabetical order:

 Name Area Institute
 Mathias Alter  Control electronics  MPIA
 Peter Bizenberger  Instrumentation Department Head  MPIA
 M. Concepción Cárdenas  Optics, AIV, System Engineer, Project management  MPIA
 Bernhard Dorner  Detector calibration NLC CAHA
 Matilde Fernandez  Principal Investigator, science  IAA-CSIC
 Julia Gallego  System engineer – web page  CAHA
 Antonio J. García Segura  User Control software  IAA-CSIC
 Ana Guijarro  Leading Support Astronomer  CAHA
 Jens Helmling  Electronics, CAHA technical responsible  CAHA
 Armin Huber  Mechanics  MPIA
 José Miguel Ibáñez  Control and data reduction software  IAA-CSIC
 Ulrich Mall  Read Out Electronics  MPIA
 Klaus Meisenheimer ♰  Principal Investigator, science  MPIA
 Richard J Mathar  Control and acquisition Software - Detector  MPIA
 Sara Muñoz Torres  Instrument astronomer  IAA-CSIC
 Vianak Naranjo  Detector, System Engineer  MPIA

 

 

PANIC team:
 

2022 panic team picture indoor

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The following people form the PANIC team, in alphabetical order:

 Name Area Institute
 Mathias Alter  Control electronics  MPIA
 Peter Bizenberger  System Engineer, AIV  MPIA
 M. Concepción Cárdenas  Optics, AIV  MPIA
 Matilde Fernandez  Principal Investigator, science  IAA-CSIC
 Antonio J. García Segura  Control software (OT)  IAA-CSIC
 Jens Helmling  Calar Alto feedback  CAHA
 Armin Huber  Mechanical Design  MPIA
 José Miguel Ibáñez  Control and data reduction software  IAA-CSIC
 Werner Laun  Cryotechnique  MPIA
 Ulrich Mall  Read Out Electronics  MPIA
 Klaus Meisenheimer ♰  Principal Investigator, science  MPIA
 Richard J Mathar  Control and acquisition Software  MPIA
 Lars Mohr  Electronics  MPIA
 Vianak Naranjo  Detectors  MPIA

 

Former team members:

There are many team members who helped make PANIC happen but who no longer work at the institute that is part of the PANIC consortium or whose direct involvement with the project has ended. We are very grateful for their contribution! The following people have been involved in the project:
Harald Baumeister (Mechanics, MPIA), Txitxo Benítez (co-Principal Investigator, IAA-CSIC), Bernhard Dorner (AIV lead and operations, MPIA), Irene M. Ferro Rodríguez (AIV, IAA-CSIC), Josef Fried ♰ (Principal Investigator, MPIA), Patrick Fopp (AIV, MPIA), Javier Gorosabel ♰ (co-Principal Investigator, IAA-CSIC), Bernhard Grimm ♰ (Electronics, MPIA), Alcione Mora (Optics, IAA-CSIC), Johana Panduro (Detectors, MPIA), José Ramos (Read Out Electronics, MPIA), Julio Rodríguez (Project Management, IAA-CSIC), Ralf-Rainer Rohloff (Mechanics, MPIA), Ernesto Sánchez-Blanco (Optical consultant, DSO), Clemens Storz (Control and acquisition software, MPIA), Víctor Terrón (Data reduction software, IAA-CSIC), Marcos Ubierna (Mechanics, IAA-CSIC), Lourdes Verdes-Montenegro (co-Principal Investigator, IAA-CSIC), Karl Wagner (Electronics, MPIA).

2022 panic team picture outdor 

 iaa csic  csic  MPIA Logo200  logo mpia nuevo  caha logo

 


logo PANIC removebg

The Observation Tool (OT) is a software package that allows high-level control of the instrument PANIC based on a Java GUI. Using this tool, the observer can design and execute his observing program with the instrument PANIC of CAHA.

 

Requirements

The OT is written in Java, due to this development, it can be used in any platform that has installed Java  Runtime Environment (JRE) Version 7.0 or higher. You can download the latest Java version from   http://www.java.com/en/download/manual.jsp

You can determine in your computer which version of Java is the default by typing in a Terminal:

    java –version

 

Download

The latest stable version of OT can be downloaded from here.

You download only one file: PANIC_OT.jar This is a crossplatform Java package that contains itself all the files that the tool needs. Ready to be run.

 

Manual

You can download the OT manual from here.

 

Running the OT

As a Java crossplatform application, you can use any operating system Java compatible.

 

Running from the command line

To run the OT from the command line, in a Terminal, move to the directory where the PANIC_OT.jar is, and type the following command:

   java -jar PANIC_OT.jar

 

Note for Mac OS X users: When launching a Java application through the command line, the system uses the default JDK (Java Development Kit). It is possible for the version of the JRE to be different than the version of the JDK.

 

Running OT by double click (only Windows and Mac OS X)

Another option to run the OT is double clicking in the PANIC_OT.jar file. Only available from Windows and Mac OS X operating systems.

 


Filters

A filter is needed for each of the four CCDs. Overall, 124 filters have been built for LAICA, both with a wide and medium wavelength range coverage:

11 wide-band filters (left table, see transmission curves of Johnson- and Sloan filters) and 20 medium-band filters (colored bands overlayed over SDSS bands in black, full optics + atmospheric transmission) designed for the ALHAMBRA cosmological survey.LAICA Alh filterset

Band name λcentral λFWHM Trans.

U_Johnson 

3500 520 Curve
B_Johnson  4200 1400 Curve
V_Johnson 5500 1150 Curve
R_Johnson 6600 1850 Curve
I_Johnson 9000 100 Curve
B2     4300 1480 Curve
u'   SDSS 3500 630 Curve
g'   SDSS 4900 1230 Curve
r'    SDSS 6200 1350 Curve
i'    SDSS 7700 1500 Curve
z'   SDSS 9200 1600

Curve